Yakima HoldUp 2 Manual De Instrucciones página 4

FOLd HOLduP dOWN.
• Pull spring pin to release base.
• Fold down holdup
• Release Pin. Pin should snap
into place.
PREPARE FOR LOAdING.
LOAd HEAVIEST BIkE FIRST.
note: Holdup can fold down
past horizontal to aid in
loading your bikes.
SWING PIVOT ARM INTO PLACE.
rotate the pivot arm
up until the hook
rests on the bike tire
1" or less from the
brakes or the fork.
1034426J-4/21
release wheelstrap by pressing the
lever on the buckle.
CAUTIon: If any part
of your bike comes in
contact with the red
trigger, do not use this
carrier with that bike.
If a fender prevents proper placement
of the wheel hook, remove the fender
for proper and safe loading.
>
2X
Tuck strap into slot at
rear of wheeltray.
Do not install if your bike
has a flat tire or has a slow
leak. Lost tire pressure
after install may result in
an insecure load.
be sure to return the holdUp to the locked
horizontal position after loading.
failure to place wheel
hook in the correct
position can cause
your bicycle to eject,
and cause personal
injury, property
damage, or death.
Be sure pivot
arms are
folded down.
Do not push
arm beyond
horizontal.