EINHELL TH-TS 1725 U Manual De Instrucciones página 31

Anleitung_TH_TS_1725_U_SPK8__ 24.09.12 14:53 Seite 31
familiar with the tool or who have not read these
instructions to use the tool. Electric tools are
dangerous if they are used by inexperienced
people.
Keep your cutting tools sharp and clean.
n
Carefully maintained cutting tools with sharp
cutting edges will jam less and are easier to
control.
If the connection lead on the electric tool is
n
damaged, it must be replaced by a specially
prepared connection lead available from our
customer service organization.
Have your tool repaired only by trained
n
personnel using only genuine spare parts. This
will ensure that you tool maintains its safety
standard.
The machine has to be set up where it can stand
n
securely.
All covers and safety devices have to be properly
n
fitted before the machine is switched on.
It must be possible for the blade to run freely.
n
When working with wood that has been
n
processed before, watch out for foreign bodies
such as nails or screws etc.
Before you actuate the On/Off switch, make sure
n
that the saw blade is correctly fitted and that the
machineʼs moving parts run smoothly.
Follow the instructions for lubrication and
n
changing tools.
Keep handles dry, clean and free from oil and
n
grease.
Keep the push stick or handle for a push block at
n
the machine at all times, even when you are not
using them.
Do not cut rebates or grooves without fitting a
n
suitable guard, e.g. a tunnel-type guard, over the
saw table.
Use only the transport device for transporting the
n
machine.
While you are moving the machine it is best to
n
cover the top part of the blade, for example using
a guard.
Do not lose these safety instructions.
Safety information on the laser
Important:
Laser radiation
Do not look into the beam
Laser class 2
Precaucion
Radiacion Laser
No mirar al haz de laser
Espeficification Laser
Segun EN 60825-1
Laser clase 2
Ï: 650 nm P: ≤ 1 mW
size: 45 x 23 mm · print black on
yellow (100% Yellow) background)
Protect yourself and your environment from accidents
by taking the appropriate precautionary measures.
Do not look directly into the laser beam with the
n
naked eye.
Never look directly into the laser path.
n
Never direct the laser beam at reflecting surfaces
n
or persons or animals. Even a low output laser
beam can inflict injury on the eye.
Caution: It is vital to follow the work procedures
n
described in these instructions. Using the
equipment in any other way may result in
hazardous exposure to laser radiation or
radioactive contamination.
Never open the laser module.
n
Safety information on the batteries
Use of the batteries
Ensure that the ON/OFF switch for the laser (35)
n
is set to its "0" position before you fit the batteries.
Inserting the batteries when the laser is switched
n
on can cause accidents.
If the equipment is not used correctly the
n
batteries may leak. Avoid contact with the battery
fluid. If you come into contact with battery fluid,
clean the affected body part with running water. If
you get battery fluid in your eyes, seek immediate
medical assistance.
Leaked battery fluid can cause skin irritation and
n
acid burns.
Never expose the batteries to excess heat such
n
as sunshine, fire or similar.
Never recharge batteries that are not suitable for
n
recharging. There is a risk of explosion!
Keep batteries away from children, do not short
n
circuit batteries or disassemble.
Seek a doctor's advice immediately if a battery is
n
swallowed.
If necessary, clean the contacts on the battery
n
and equipment before inserting the batteries.
GB
31