Makita DTD134 Manual De Instrucciones página 7

NOTE:
• If the bit is not inserted deep enough into the
sleeve, the sleeve will not return to its original
position and the bit will not be secured. In this
case, try re-inserting the bit according to the
instructions above.
• When it is difficult to insert the bit, pull the
sleeve and insert it into the sleeve as for as it
will go.
• After inserting the bit, make sure that it is firmly
secured. If it comes out, do not use it.
Hook
► 1. Hook 2. Screw
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
OPERATION
1
2
The proper fastening torque may differ depending upon
the kind or size of the screw/bolt, the material of the
workpiece to be fastened, etc. The relation between fas-
tening torque and fastening time is shown in the figures.
Standard bolt
N m
(kgf cm)
120
(1,224)
100
(1,020)
80
(816)
60
(612)
40
(408)
20
(204)
0
Fastening time (S)
High tensile bolt
N m
(kgf cm)
120
(1,224)
100
(1,020)
80
(816)
60
(612)
40
(408)
20
(204)
0
Fastening time (S)
7 ENGLISH
M14
M12
(M14)
M10
(M12)
M8
(M10)
1.0 2.0 3.0
M12
M10
(M10)
M8
(M8)
1.0 2.0 3.0
(M8)
(M12)