Mitsubishi Electric MXZ-3C24NA2 Manual De Instalación página 5

2. UTD UNIT INSTA
2- . INSTA ING T E UNIT
depth deeper.
2-2. C NNECTING WI ES F
it to the unit with screws.
7) Perform 5) and 6) for each indoor unit.
8) Connect power supply cord (A).
TION is completed.
Connecting order
following order.
A C D P
emark:
** Use a ring tongue terminal in order to connect a ground wire to terminal.
INDOOR UNIT
Grounding
terminal **
20 /230 AC
phase 60
Disconnect
switch *
Grounding
terminal **
A – C D
ATI N
Fix here with
M10 bolts.
UTD UNIT
-
Power supply
A – C D
(15 mm)
Lead wire
Power supply
OUTDOOR UNIT
Anchor leg
Anchor bolt length Anchor bolt pitch
ELECTRICAL SPECIFICATIONS
OUTDOOR UNIT
Max. Fuse size (time delay) (A)
Min. Circuit Ampacity (A)
Fan motor (F.L.A)
(R.L.A)
Compressor
(L.R.A)
Indoor unit-Remote controller : (Wireless)
Screws
Connect wires to the matching numbers of terminals.
Be sure to attach each screw to its correspondent terminal when
securing the cord and/or the wire to the terminal block.
C NNECTING WI ES AND C NNECTING G
* Follow local electrical code.
P WE SUPP CAB E AND G
Grounding * Follow local electrical code.
terminal **
WA NING:
Use the indoor/outdoor unit connecting wire that meets the Stand-
ards to connect the indoor and outdoor units and x the wire to the
terminal block securely so that no external force is conveyed to the
Ground
connecting section of the terminal block. An incomplete connection
or xing of the wire could result in a re.
(600)
(Unit: inch (mm))
25
22.1
12
Conduit plate
Conduit connector
Conduit plate
UND WI E
UND WI E
12
En-4