Transferring Measurements - Beurer BM 77 Manual De Instrucciones

To clear individual measurements from the relevant user
memory, you must first select a user memory.
• Start the retrieval of the individual measured values.
• Press and hold the memory buttons M1 and M2 for
5 seconds.
• The selected value is deleted. The device briefly dis-
plays CL 00.
• If you would like to delete other values, repeat the pro-
cess described above.
You can switch off the device at any time by pressing the
START/STOP button.

8. Transferring measurements

USB interface
Connect the blood pressure monitor to your PC using the USB
cable.
No data transfer may be launched whilst
performing a measurement.
PC is shown on the display. Begin the data transfer
in the "HealthManager" PC software. During the
data transfer, an animation is shown on the display.
A successful data transfer is displayed as in
figure 1. If the data transfer is unsuccessful, an
error message appears as in figure 2. In this case,
interrupt the PC connection and start the data
transfer again.
After 30 seconds of not being in use or if communication with
the PC is interrupted, the blood pressure monitor switches
itself off automatically.
Transfer via Bluetooth
It is also possible to transfer the measured values saved on the
device to your smartphone using Bluetooth
You will need the Beurer "HealthManager" app for this. Install
the „Beurer HealthManager" from the Apple App Store or Goo-
gle Play. Proceed as follows to transfer values:
If Bluetooth
®
transferred automatically after the measurement. The
appears in the top left of the display (see chapter 4 "Preparing
the measurement").
figure 1
figure 2
33
®
is activated in the settings menu, the data is
Step 1: BM 77
Activate Bluetooth on your device (see
®
chapter 4 "Preparing the measurement, Blue-
tooth ").
®
Step 2: Beurer "HealthManager" app
In the Beurer "HealthManager" app, add the
BM 77 under "Settings/My devices".
Step 3: BM 77
take a measurement.
.
®
symbol