SAFETY OPERATING INSTRUCTIONS
PLEASE READ BEFORE USE
The substances used with this spray applicator (paint, thinners etc) may contain hazardous,
harmful, explosive or corrosive materials.
G
The spray applicator must only be used with paints and solvents that have a suitable flash point
for spraying. If in doubt, consult the paint or solvent manufacturer's data
G
Always ensure there is adequate ventilation when spraying.
NEVER spray near an open flame, including an appliance pilot flame.
G
NEVER smoke when spraying.
G
Always disconnect the unit from the mains supply cleaning the spray applicator.
G
Always ensure the spray area is safe and free from all debris that may present a fire or trip hazard.
G
NEVER, under any circumstances, point the spray gun at another person or animal. In the
G
event of injury occurring, seek expert medical advice immediately.
G
NEVER allow children or unauthorised users to operate or play with the spray equipment.
This equipment is for professional use only.
G
Always read the paint manufacturer's thinning instructions before use.
Always wear the correct protective face mask when spraying. We also recommend wearing
G
gloves, goggles and overalls.
G
After every use ensure that you clean the spray gun thoroughly and grease the gland washer.
Use only genuine manufacturer replacement parts.
G
Only use the spray equipment as detailed in these instructions.
G
Do not use the air hose or mains cable to pull the HVLP unit.
G
Check the hoses, hose connectors and mains cable daily. Any worn or damaged parts should
G
be replaced immediately.
G
This appliance is recommended for household use only.
This appliance is not intended for use by persons (including children) with reduced physical,
G
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
G
given supervision or instruction concerning use of the appliance by a person responsible
for their safety.
WARNING: The substances used with this Spray Gun (paints, solvents, etc.) may contain
dangerous, harmful, explosive or corrosive materials. ALWAYS COMPLY WITH THE
SAFETY INSTRUCTIONS ISSUED WITH THIS PRODUCT AND THE MATERIAL BEING USED.
Only use the Spray Station as described in this manual.
TECHNICAL SPECIFICATION:
Wattage: 1100 Watts
Voltage: 120 V (60hz)
Air output: 22L/sec
Sound pressure level: 88 dB (A)
Fig.1
PARTS LIST
No Description
1.
Air Cap Ring
2.
Air Cap
3.
Air Distributor Plate
4.
0.08" (2.0mm) Fluid Tip
5.
Fluid Tip Seal
6.
Pivot Screw
7.
Washer
8.
Main Body Assy
9.
0.08" (2.0mm) Fluid Needle
10.
Adaptor
11.
Needle Spring
12.
Fluid Adjusting Screw
13.
Pivot
Container capacity: 1 litres
Air hose length: 4.5 m
Dynamic air pressure: 0.30 bar
Maximum viscosity: 250DIN/sec
Part No
L0151
L0517
L0162
L0157
L0159
L0179
L0195
L0180
L0166
L0174
L0175
L0176
L0178
Optional Accessory to Purchase 30ʼ Hose - N0099
No Description
14.
Flexible Tube Air Feed
15.
Gland Nut
16.
Gland Seal (2 pcs)
17.
Trigger
18.
Centre Bolt & Pick Up Tube Assy
19.
Yoke
20.
Clamp Lever
21.
Shim
22.
Lid Assy
23.
Gasket
24.
Centre Bolt Nut
25.
Paint Container
26.
Filter (x2)
27.
Air Hose
2
Part No
L0182
L0173
L0168
L0177
L0183
L0184
L0185
L0186
L0187
L0188
L0189
L0190
N0087
N0212