Operation; General Operation; Switching On/Off The Unit; Sound Adjustment - Lenco CS-315 Manual Del Usuario

GENERAL OPERATION

1 2
3
/
7 M OD
8/
9/
AUX
IN
RESET
21 20

SWITCHING ON/OFF THE UNIT

Press any button to turn on the unit.
When the unit is on, Press and hold
button (14) to turn the unit off.

SOUND ADJUSTMENT

Press SEL button (3) shortly to select the
desired adjustment mode. The adjustment
mode will change in the following order:
BAS → TRE → BAL → FAD → EQ → VOL
By pressing the vol+/- button (4) to adjust the
desired sound quality.
LIQUID CRYSTAL DISPLAY
Exhibit current frequency and activated
functions on the display (5).

AUXILIARY INPUT

The unit can be connected to a portable
audio player through the AUX IN jack (21).
USB INTERFACE
On the front panel of the unit, there is an
USB interface (11). You can connect an
USB driver through this interface (11).
DISPLAY
Repeatedly press DSP button(8) to show
the information as below:
TIME->FREQ.->PTY->PS
4
VOL +
SEL
VOL -
1 2
INT
19 18
5
3 4 5
RPT RDM DIR-
17 16 15 14
It will return back to current state after 5
seconds.

Adjust the clock

In time mode. Press and hold for 2 seconds.
The "HH" will flash, Use
change the HOUR. Press DSP again. The
"MM" will flash. Use
change the minute. Press and hold it again
will exit this mode after finished. Or it will
exit this mode automatically after 10
seconds.

RESET FUNCTION

RESET button (20) must be activated with
either a ballpoint pen or thin metal object.
The RESET button is to be activated for the
following reasons:
- Initial installation of the unit when all
wiring is completed.
- All the function buttons do not operate.
- Error symbol on the display.

RADIO OPERATION

SWITCHING TO RADIO MODE

Press MODE button (1) shortly to select
radio mode, the radio mode appears in the
display together with the memory band and
frequency
8
6 7 8
AS/PS
BND/PTY
DSP/0
6
DIR+
12
13
/ button (2) to
/ button (2) to
9
AF
REG
TA
11 10