PULOX PO-200 Manual De Instrucciones página 27

3) Let the patient's finger put into the rubber cushions of the clip
(make sure the finger is in the right position), and then clip
the finger.
4) Press the switch button once on front panel.
5)
Do not shake the finger and keep the patient at ease during
the process. Meanwhile, human body is not recommended in
movement status.
6) Get the information directly from screen display.
7) The device could change display direction according to the
handing direction.
Fingernails and the luminescent tube should be on the same
side.
8. Cleaning, Transportation and Storage

Please change the batteries when the low-voltage displayed
on the screen.

Please clean the surface of the device before using. Wipe the
device with medical alcohol first, and then let it dry in air or
clean it by dry clean fabric.

Using the medical alcohol to disinfect the product after use,
prevent from cross infection for next time use.

Please take out the batteries if the oximeter is not in use for a
long time.

The best storage environment of the device is -40ºC to 60ºC
ambient temperature and not higher than 95% relative
humidity.
High-pressure sterilization cannot be used on the device.
Figure 5 Finger Position
EN