Principle Of Operation; Installing The Appliance; General Remarks - STAMOS 6111 S-LS-12 Manual De Instrucciones

PRINCIPLE OF
OPERATION
Assembly:
5
BEFORE FIRST USE
Upon receipt of the goods, check the packaging for integrity and open it. If the packaging is damaged, please contact your
transport company and distributor within 3 days, and document the damages as detailed as possible. Do not turn the package
upside down! When transporting the package, please ensure that it is kept horizontal and stable. Please keep all packaging
materials (cardboard, plastic tapes and styrofoam), so that in case of a problem, the device can be sent back to the service
centre in accurate condition.
Disposing of packaging
The various items used for packaging (cardboard, plastic straps, polyurethane foam) should be conserved, so that the device
can be sent back to the service center in best conditions in case of problem!

INSTALLING THE APPLIANCE

Appliance location
The work surface where the device will be located must be suitable for the size of the appliance, please refer to the mea-
surements. The work surface must be levelled, dry, heat-resistant and at a fitting height from the ground to enable a proper
use of the device.
The power cord connected to the appliance must be properly grounded and correspond to the technical details.
OPERATION
1. Device must be placed on stable work table, soldering iron must be placed into the holder.
2. Fix the appropriate soldering tip and connect the device to the power source.
3. Turn on the soldering iron with switch (1), it will start to heat.
4. Set the desired temperature using knob (2). Display (4) will show this temperature for a moment and then it will
show the actual temperature of the soldering iron.
5. Heat indicator (5) lights during heating. When the soldering iron reaches the set temperature, indicator flashes regu-
larly.
6. After work, the soldering iron should be placed into the holder. Turn off the soldering station by switch (1).
Switch (3) is designed for changing the temperature units between Celsius and Fahrenheit (⁰C – Celsius, ⁰F – Fahrenheit)
CHANGING THE TEMPERATURE DISPLAY UNITS

GENERAL REMARKS

1. If the display is showing "S-E" it means that soldering iron is disconnected.
2. When the device is being turned on, the soldering iron should be placed in the holder.
3. Good ventilation of the room in which the appliance is used must be provided. In addition, the device should be
placed in a location with good air circulation to dissipate heat.
8
4
3
6
EN
1.
1
2.
3.
2
4.
5.
6.
on / off switch
soldering iron temperature setting knob
temperature unit switch
soldering iron temperature display
working (heating) indicator
soldering iron connection socket