Principle Of Operation - STAMOS S-LS-6 Manual De Instrucciones

CAUTIONS
General safety information for the use of electrical devices:
To avoid injury from fire or electric shock, please ensure compliance with safety
instructions when using this device. Please read the instruction carefully and make
sure that you have understood it well. Keep the manual near the equipment to be
able to read it at any time. Always use current sources connected to the ground and
providing the necessary voltage (indicated on the label on the device). If you have any
doubt, let an electrician check that your outlet is properly grounded. Never use a da-
maged power cable. Do not open the unit in damp or wet environment, or if you are
wet yourself. Protect the unit of solar radiation. Use the device in a protected locati-
on to avoid damaging the equipment or endangering others. Make sure the device is
able to cool and avoid placing it too close to other devices that produce heat. Before
cleaning, disconnect it. Use a soft damp cloth for cleaning. Avoid using detergent and
make sure that no liquid enters the unit. No internal element of this device needs to
be maintained by the user. An opening of the device without our approval leads to a
loss of warranty.
General safety information for the use of the device:
• The user manual should be kept close to the device and should always be acces-
sible for the users. Instruct your employees how to use the device properly.
• Make sure the hot air can circulate well and place the device more than10 cm
away from walls and other electrical devices. Aerate well the working area.
• Do not place the device close to combustible materials.
• It may happen that by first use, the heating element produces a light smoke. This
is absolutely normal. Simply check that the smoke can evaporate and that a good
aeration is provided.
• Some parts of the device can get extremely hot. To avoid any injuries, be careful
by every contact with the device.
• Clean the device regularly to avoid a durable encrustation of dirt.
TECHCNICAL DETAILS
Modell
Voltage (V)
Rated current (A)
Power (W)
Work temperature (⁰C)
14
EN
6105 S-LS-6
230 ~ 50Hz
6
720
0/+40
Storage temperature (⁰C)
Storage humidity
SOLDERING STATION
Temperature range (⁰C)
Output power (W)
Temperature stability
Tip resistance to ground
Tip-to-ground voltage
SMD REWORK STATION
Temperature range (⁰C)
Output power (W)
Temperature stability
Airflow (L/min)
USAGE PURPOSE
The device is designed for:
1. Different kind of soldering, de-soldering of the electronic components such as:
SOIC, CHIP, QFP, PLCC, BGA, SMD, etc.
2. Shrinking, paint drying, adhesive removal, thawing, warming, plastic welding.
Any damage resulting from a non-conform use of the device is payable by the user!

PRINCIPLE OF OPERATION

EN
-20/-80
35% / 45%
100-480
±1 ⁰C
75
<2ohm
<2mV
100-480
550
±1⁰C
28
15