Regular Cleaning - STAMOS 6111 S-LS-12 Manual De Instrucciones

SAFETY ISSUES REMARKS
1. Tips can be changed when the soldering iron is completely cold.
2. It is forbidden to use the device near the flammable or combustible elements and objects or at similar places. Solde-
ring iron tips have very high temperature, it is forbidden to touch these elements. This can cause serious burns.
3. Too high temperature of the soldering iron may be the cause of reduction of the functionality of the soldering tips.
4. Soldering iron tip must be cleaned regularly using sponge and plate on a layer of tin to prevent tips oxidation.
REPLACEMENT OF THE SOLDERING IRON TIP AND SOLDERING IRON HEATING CORE ELE-
MENT
3
2
1
6

REGULAR CLEANING

Generalities
• Never clean the device with a pressurized water-jet, industrial cleaners, and brushes or any other type of cleaning
utensil that could damage the surface of the appliance.
• Before cleaning you must remove the electricity supply plug isolating the appliance from the main power circuit.
REGULAR CONTROL OF THE DEVICE
Control regularly that the device doesn´t present any damage. If it should be the case, please contact your customer ser-
vice to solve the problem.
What to do in case of problem?
Please contact your customer service and prepare following information:
• Invoice number and serial number (the latest is to be found on the technical plate on the device).
• If relevant, a picture of the damaged, broken or defective part.
• It will be easier for your customer service clerk to determinate the source of the problem if you make a detailed
and precise description of the matter. Avoid formulations like "the device doesn´t heat", which may mean that it
doesn´t heat enough or even not at all. Though, those two possibilities have a different causation!
The more detailed your information, the quicker the customer service will be able to answer your problem rapidly and
efficiently!
CAUTION: Never open the device without the authorization of your customer service. This can lead to a loss of warran-
ty!
EN
5
4
8
7
1. nut for mounting the soldering iron tip
housing
2. soldering iron tip housing
3. soldering iron tip
4. plastic nut for mounting the heater and the
board wires
5. spring
6. heater
7. wires board
8. handle
9