Rechargeable Batteries/Batteries; Insert /Replace Rechargeable Batteries/Batteries; Maintenance/Care; Maintenance - Nedo ACCEPTOR pro Manual De Instrucciones

EN Operating instructions
6 Rechargeable batteries/batteries
6.1 Insert /replace rechargeable batteries/batteries
The ACCEPTOR PRO requires 3 rechargeable batteries/
batteries size AA 1.5V to run.
1. Lever the clip of the battery compartment flip to the
outside, unlock and open battery compartment.
2. Pull on the battery tape to undo and remove
2 rechargeable batteries/batteries 3. Undo
rechargeable battery/battery by hand and also remove.
3. Insert rechargeable batteries/batteries; ensure that the
battery tape is posited back under the top 2
rechargeable batteries/batteries. Note polarity.
4. To close the cover, press down on it until it audibly latches
into position with a click.
CAUTION!
Check that the battery tape is not positioned between the battery
compartment flap and the seal, as otherwise the housing tightness is no
longer ensured.
7 Maintenance/Care
7.1 Maintenance
The ACCEPTOR PRO are maintenance free units. If the ACCEPTOR PRO
no longer function due to an internal error (error messages Err9-Err11) or
damage, send them for repair to:
NEDO GmbH & Co. KG
Service-Abteilung
Hochgerichtstraße 39 – 43
72280 Dornstetten / Germany
7.2 Care
The laser diode of the rotating laser is protected by glass covers. Use a soft
cloth to regularly clean the glass covers and ensure correct operation. Avoid
scratches in the glass covers. Dirt on the laser reception field of the ACCEP-
TOR PRO affects the reception quality and range of the laser receiver.Use
standard cleaning agents to clean the dustproof and watertight, partly rubbe-
rised housing. Use plenty of water to remove heavy soiling.
CAUTION!
Do not immerse ACCEPTOR PRO in water.
17