Migatronic AUTOMIG PULSE Serie Manual De Instrucciones página 13

Connection and start-up
Adjustment of wire brake
The wire brake must be adjusted so as to stop the wire reel before the
welding wire runs over the edge of the reel. The brake force depends on
the weight of the wire reel and the wire feed speed. Factory setting is:
15 kg (Automig Single/Duo) or 5 kg (Automig Trio).
Adjustment:
• Dismount the control knob by placing a
thin screw driver behind the knob and
then pull it out.
• Adjust the wire brake by fastening or
loosening the self-locking nut on the
axle of the wire hub.
• Remount the control knob
Adjustment:
• Adjust the wire brake by fastening or
loosening the self-locking nut on the axle
of the wire hub.
Assembly of parts in wire feed unit
Adjusting the 15 kg wire brake
Adjusting the 5 kg wire brake
1
2
x4
Software update
• Insert the SD-card
• Turn on the
machine
• Wait until the unit
indicates that the
update is complete
• Turn off the machine and remove the SD card
• The machine is now ready for use
New software will be loaded into power source and all
connected units.
The software can be downloaded from
http://migatronic.com
Licence SW
If you purchase MIGALOG software, load the MigaLic.dat
files like the software packages. Note! Create a backup
of the files.
The MigaLic.txt file contains information about licence
number and licences saved on SD card.
Note:
1
Place soft wires as high as possible to avoid
contamination and dropping of metal chips; i.e. place
wire drive rolls with U-grove at the top and wire drive
rolls with V-grooves at the bottom in Duo/Trio models.
2
Recommended order:
1) Aluminium
3
2) CuSi/CuAl (MIG brazing)
3) Mild steel
Adjust the pressure of the thumbscrew so that
the wire feed rolls run smoothly on the wire
when it is stopped at the contact tip
13