As
soon as the robot reaches the water surface, locate the grip that is underneath the base and indicated with the hand
symbol (see diagram below) to facilitate retrieval from the pool. Make sure to always grip the robot from this end to prevent
debris from falling back into the pool during retrieval.
5. Slide the power switch OFF. Rinse the robot with fresh water after every use. DO NOT use any detergent.
6. Dry the charging port and pins thoroughly (TIPS: Use cotton bud to dry them)
NOTE: To ensure the most efficient cleaning, when your pool is quite dirty, it is recommended to empty the debris compart-
ment after the first 30min of operation, or whenever the robot's movement has slowed down noticeably. Then return the robot
(with an emptied debris compartment) to the pool, and let it run through the remaining of its cycle.
EMPTYING THE DEBRIS COMPARTMENT
WARNING! Using the robot without its filter cover in place will VOID your warranty.
In order to maximize the cleaning efficiency, clean the debris compartment and the filter cover before and after each use.
CAUTION! Before cleaning the debris compartment, make sure the robot is OFF.
1. Place the cleaner on a flat surface. Pull one side clip outwards to lift one side of the cover and repeat the steps on the other
side to lift the entire top cover to expose the filter cover.
2
4
1
3
9