Kokido DELTA 200 Manual De Usuario página 15

Ocultar thumbs Ver también para DELTA 200:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 30
Problem
Possible Cause
Debris escapes
Suction mouth's flap (at cleaner
bottom) is damaged
from the robot
Debris clogged at suction mouth and
prevents the flap to close
Debris leaks outside
Filter cover net is damaged
at the filter cover
Round float sinks
Damaged float and water leakage
Retrieval cord is kinked
Retrieval cord length is too long
Duration of cleaning
Battery is not fully charged
cycle is shorter than
advertised
Robot cannot be
Battery is damaged
charged / recharged
Charging plug is not completely
connected with external adaptor
and robot
External adaptor is out of order
Environmental Programmes, WEEE European Directive
Please respect the European Union regulations and help to protect the environment.
Return non-working electrical equipment to a facility appointed by your municipality that properly recycles
electrical and electronic equipment. Do not dispose them in unsorted waste bins. For items containing removable
batteries, remove batteries before disposing of the product.
© 2020 Kokido Development Ltd.
All rights reserved. No part of this document may be reproduced or transmitted in any form or by any means,
electronic, mechanical, photocopying, recording, or otherwise, without prior written permission of
Kokido Development Ltd. (V3)
If soft copy of this instruction manual is required, please contact our customer service by email:
customerservice@kokido.com
Manufacturer: Kokido Development Limited. Unit 1319, Sunbeam Centre, 27 Shing Yip Street, Kwun Tong, Kowloon, HK
SAVE THESE INSTRUCTIONS
Solution
Suction mouth's flap works like a door to prevent the debris
from escaping from the debris compartment. Contact dealer
for replacement parts and instruction.
Remove clogged debris from the suction mouth.
Replace with a new filter cover from your dealer.
Replace with a new float from your dealer.
Adjust the length according to instructions in the manual
Charge the robot for at least 6 hrs. NOTE: if any stains are
found on the charging pins, remove them by using a cotton
bud soaked with lemon juice or vinegar.
Contact dealer for battery replacement.
WARNING! DO NOT replace the battery by
yourself. This could result in severe or fatal
injuries and the warranty will be voided as a result.
Make sure that the charging plug is connected with
external adaptor and robot properly and completely.
Refer to instruction manual.
Contact dealer for replacement.
WARNING! Using the wrong external adaptor
will result in damaging the robot / battery and
voiding the warranty as a result.
Made in China
20008024
14

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Rc26

Tabla de contenido