Shark GI405Z Manual Del Propietário página 4

OPERATING INSTRUCTIONS
4. Place the iron on its heel on a
stable, protected surface and allow
the iron to heat for approximately
two (2) minutes or until the
temperature settings on the right
side of the LED display panel have
stopped flashing.
5. Turn the variable steam control dial
to the right to increase the amount
of steam. When using extra steam,
the iron uses more water and it may
be necessary to fill the water tank
more often. (Fig. 2)
Fig. 2
BURST OF STEAM/X-TENDED
TM
STEAM BURST BUTTON
CAUTION!
DO NOT aim iron at face,
towards yourself, or anyone else
while using or adjusting steam.
Burns or serious injury may occur.
The burst of steam position is useful
when ironing denim, cotton, and linens.
It provides quick bursts of steam which
aid in removing stubborn wrinkles.
The burst of steam feature can be used
with Dry or Steam ironing as desired.
1. Make sure the water tank is at least
1/2 filled with water.
2. Select the desired fabric and
temperature setting. Place the iron
on its heel (on a stable, protected
surface) and allow it to heat for
approximately 2 minutes.
3. Turn the steam button to the left to
the burst of steam position. (Fig. 3)
Fig. 3
4. With the iron in a horizontal
position, press the steam button
several times to prime the pump.
Note:
If the tank runs dry, remove the
plug from wall outlet. Then, fill the iron
with water and re-prime the pump. The
iron may be filled with water while it is
hot.
To use the X-Tended Steam Burst
feature:
1. Set the variable steam control dial
to the desired steam setting.
2. Press the electronic temperature
control button until you get to the
desired fabric setting.
3. Turn the steam button clockwise to
the X-Tended steam position.
(Fig. 4)
4. To maintain a constant flow of
steam, make sure that the water
tank is at least half full.
X-Tended
Steam
Burst
Fig. 4
5
ATOMIZER SPRAY NOZZLE
The atomizer spray nozzle is useful
on fabrics with stubborn wrinkles.
Press the spray button and a jet of
water will spray onto the fabric
being ironed. (Fig. 5) The water
spray can be used with dry or steam
ironing as desired.
Fig. 5
SELECTING IRON
TEMPERATURES
Always read garment labels and follow
TM
the manufacturer's ironing instructions.
Refer to the "Ironing Chart" on page 9
for temperature recommendations:
• Use low settings for nylon and other
synthetics.
•• Use moderate settings for wool,
silks, and blends.
••• Use high settings for cottons and
linens.
1. Stand the iron upright on its heel.
2. Plug the cord into a polarized, 120V
AC electrical outlet.
3. Press the electronic temperature
control until you get the desired
fabric/temperature setting.
4. The light on the right side of the
LED display panel will stop flashing
when the desired temperature has
been reached. (Fig. 6)
OPERATING INSTRUCTIONS
ELECTRONIC AUTO-OFF
The INTELLIGENT ELECTRONIC
IRON is equipped with an electronic
auto-off. The electronic auto-off
switches the iron off if it has been left
standing unmoved in any position
(sideways, flat or upright) for
approximately 7-9 minutes. A red light
on the LED display panel will flash
when the iron switches itself off. (Fig. 7)
To switch the iron back on, just shake
the iron side-to-side several times until
the "Power ON" light is re-illuminated.
Then re-set the temperature to the
desired setting.
Note: The iron may require additional
warm-up time if the auto-off feature
was activated for an extended period.
Fig. 7
6
Temp.
settings
Fig. 6
Flash