General Rules - SUOMY MX TOURER Manual De Instrucciones

GENERAL RULES

Eng
Do not use scarves or chin rests that could facilitate the sliding of the strap and the removal of the helmet if it receives a blow.
MX TOURER has been designed to be used with most glasses on the market. In any case it is necessary to check the helmet fit wearing your
usual glasses before purchase.
The helmet's function is to reduce stresses on the user's head in the event of receiving a blow; this takes place through the partial destruction
and/or deformation of its components (mainly the outer shell and the inner shell made of polystyrene). In this way part of the energy generated
by a blow is absorbed by the helmet's components, thus reducing the stresses on the user's head by eliminating or limiting the possibility of
the occurrence of a trauma. It is obvious that the protection capacity of the helmet is not infinite and that certain blows may generate stresses
so high that the energy absorbed by the helmet is not sufficient to prevent trauma to the user: no helmet, even if it one of the highest level,
can protect your head from the forces generated by all the different types of blows.
The integrity of the shell and its interior is essential to ensure best performance in terms of safety. MX TOURER is designed to absorb blows
through a partial destruction of the shell or some of its parts that could therefore be damaged after a blow even if this damage is not visible. In
case of further stresses the helmet may no longer be able to protect you as well as possible.
Never use a helmet that has sustained a blow, even if no visible damage can be seen; if it receives a blow the helmet must be replaced.
It is extremely dangerous to modify the helmet by attaching or gluing something to it. Never cut or puncture the helmet, do not insert
screws into it, and do not paint it.
Do not make any changes to the helmet's lining. In particular, the inner polystyrene padding must never be cut or changed: alterations to the
shape of the inner polystyrene shell may affect the helmet's safety characteristics.
Damaged visors may reduce visibility, especially at night, and they must be replaced immediately with visors which are properly certified in
accordance with approval regulations.
Do not paint the visor and/or apply adhesives to it. Never peel off the visor's certification label.
Use only original Suomy accessories and spare parts, or those expressly recommended by Suomy for this helmet model: only in this way can
reliability, safety and compatibility with the helmet you use be ensured.
20