Master Switch - Tre Spade ATACAMA PRO DELUXE Manual De Instrucciones

English
WARNING
ENTFERNEN DER
NEVER CUT OFF THE POWER TO THE DE-
SICHERHEITSVORRICHTUNGEN
STRENGSTENS
HYDRATOR BY REMOVING THE PLUG.
VERBOTEN
REMOVE THE PLUG FROM THE SOCKET
N. 91.001.065
ONLY AFTER THE MOTOR HAS SHUT
DOWN, WITH THE MASTER SWITCH PO-
SITIONED TO (O). BEFORE SHUTTING
DOWN THE MOTOR USING THE SWITCH
(I-O), IT IS RECOMMENDED TO HAVE
IM BRANDFALL
KEIN WASSER AUF
THE FAN ROTATE FOR SOME MINUTES
ELEKTROANLAGEN
DIE UNTER STROM STEHEN
BY BRINGING THE ADJUSTING KNOB IN
N. 91.001.066
0 POSITION.
PRO and PRO DELUXE Version:
REINIGEN UND/ODER
SCHMIEREN BEI
MASCHINENBETRIEB
STRENGSTENS VERBOTEN
N. 91.001.068

Master switch:

Insert the plug and switch the master switch to
(I) to power the dehydrator prior to starting any
process. The dehydrator switches on and goes in
stand-by mode, the display indicates the applian-
ce is (On). Positioning the switch to (O) cuts the
power supply to the electronic board.
WARNING
ENTFERNEN DER
NEVER CUT OFF THE POWER TO THE DE-
SICHERHEITSVORRICHTUNGEN
STRENGSTENS
HYDRATOR BY REMOVING THE PLUG.
VERBOTEN
REMOVE THE PLUG FROM THE SOCKET
N. 91.001.065
ONLY AFTER THE MOTOR HAS SHUT
16
DOWN, WITH THE MASTER SWITCH PO-
SITIONED TO (O).
Key :
In stand-by condition (the screen displays the
message "ON"), press repeatedly the
the number of program (see table 1) to set up is
displayed (in this condition both LEDS will blink).
Key
Starts and stops the drying cycle. To resume the
process after being stopped (PAUSE), press again
the key . The program will restart from the point
in which it has been interrupted.
To reset the program while is running, press and
hold for 3 seconds until the screen displays the
message (On). This operation resets the drying
cycle previously set and causes the dehydrator to
go in stand-by condition.
WARNING
If the dehydrator is reset at an operating tempe-
ENTFERNEN DER
SICHERHEITSVORRICHTUNGEN
rature greater than 40°C, the electronic board will
STRENGSTENS
Fig. 2
VERBOTEN
stop the cycle, but the fan will keep running at
N. 91.001.065
maximum speed up to lower the temperature of
the motor and bring it to 40°C to prevent it goes
damaged. During this operation both LEDS blink.
Display and indicator lights:
During the drying process, the display alternately
IM BRANDFALL
KEIN WASSER AUF
shows the operating temperature detected at the
ELEKTROANLAGEN
DIE UNTER STROM STEHEN
moment (indicator light
N. 91.001.066
at the end of the drying program (indicator light
on) and the program currently in use (indica-
tor lights off). The remaining time is expressed in
hours up to the last hour; the countdown is ex-
pressed in minutes (this function can be identified
REINIGEN UND/ODER
thanks to the lit point that follows the value).
SCHMIEREN BEI
MASCHINENBETRIEB
STRENGSTENS VERBOTEN
N. 91.001.068
Made in Italy
:
on), the time remaining
key until