Tre Spade ATACAMA PRO DELUXE Manual De Instrucciones página 19

Programs:
The dehydrator is equipped with an electronic
control system, which ensures a wide range of
simple and effective programs suitable to all uses
and product types. The programs are designed by
taking into account all variables involved in the
drying process; they differ in temperature, dura-
tion and air flow speed.
All automated programs described below display
the duration in hours and envisage a final phase
that allows preserving the products at best drying
level with minimum energy consumption. Once
the drying process is completed, the appliance
preserves the product at the moisture level rea-
ched and prevents rehydration until the product
is withdrawn.
PROGRAM
EVO (customized)
AUTO
THIN
BIO
HOT
PASTA
ECO
DELAY
P1 – EVO
(customized settings program):
allows setting up and control all parameters of the
drying process.
It is possible to set the drying time (1h - 72h), the
operating temperature (20°C - 68°C) and the fan
speed (i.e. the air flow) (levels 1 - 2 - 3 - 4).
ting the EVO program:
• Press the key to access the EVO program.
The display shows P1 (the LEDS are blinking).
• Press the key to access the writing box.
• The LED blinks and the display shows the
temperature (20°C). Press the
all settable temperatures in sequence.
• Once the necessary value is found, confirm
Display Hours T°C
P1 1-72 20-68
A1 30 55
A2 18 50
A3 30 45
A4 15 68
A5 20 40
A6 30 45
H0 1-9
key to display
Made in Italy
using the key
• The LED
message (- -). Press the key to display all setta-
ble hours in sequence.
• Once the necessary value is found, confirm
using the key
• The LEDS are off and the display shows the value
(L4). Press the
flow levels.
L4 - 2000 RPM
L3 - 1600 RPM
L2 - 1300 RPM
L1 - 900 RPM
• Once the necessary value is found, confirm
using the key
• At this point both LEDS blink and the display
shows P1. The dehydrator is ready to start the
drying cycle as soon as entered.
• Pressing the key
according to the parameters set
The EVO program parameters set are not stored
on the electronic board. It is therefore recommen-
ded to write them down in the special notes sec-
tion at the end of this manual.
A1- AUTO: designed to dry every product type, is
-
suitable both for first drying experience and un-
certainty on which program to use. It has 30h du-
ration at an average temperature of 55°C.
A2- THIN: short program with average tempera-
ture values. Suitable for dry fruits and vegetables
cut into thin slices (max 5mm). The program is also
recommended to obtain the best dried mushro-
oms. It has 18h duration at maximum temperature
value of 50°C.
A3- BIO: safeguards the organoleptic properties
and nutritional values of dried products. Suitable
for bio and raw food or, more generally, for those
who do not want cooked foods. It has 30h dura-
tion at maximum temperature value of 45°C.
A4- HOT: is the program that runs the dehydrator
at the highest temperature. Recommended when
the drying process has to be accelerated. It can
.
blinks and the display shows the
.
key to display the 4 preset air
.
starts the drying cycle
English
17