Installation; Installation Information; Installation Place; To Perfect Your Installation - EAS ELECTRIC EBP Serie Manual De Instrucciones

5. INSTALLATION

5.1 Installation information

The following information given here is not an instruction, but simply meant to give the user a better
understanding of the installation.

5.2 Installation place

Install the swimming pool heat pump on a flat, horizontal, and stable surface. Maintain 1 M of open space in
front of the discharge grids and 3 M on the outlet side of the ventilator. And reserve enough space to allow
access to temperature controller.
Make sure that the discharged air will not be breathed in.

5.3 To perfect your installation

--Avoid directing the flow of ventilated air towards a sensitive noise zone, such as room window.
--Avoid positioning pool heat pump on a surface that can transmit vibrations to dwelling.
--Try to avoid placing appliance under a tree or exposed to water or mud, which would be likely to complicate
maintenance.

5.4 Water connection

The heat pump is connected to a filtration circuit with a by-pass.
It is imperative that the by-pass is placed after the pump and the filter. The
by-pass generally consists of 3 valves.
This makes it possible to regulate the water flow which passes through the heat pump and to isolate the heat
pump completely for any maintenance work, without cutting the flow of filtered water.
During the first months of use, your heat pump is subject to condensation. This will result
8
V.2