Set Temperature; Set Parameter; Display On Each Status; Function Diagnosis - EAS ELECTRIC EBP Serie Manual De Instrucciones

6.3.2 Set Temperature

When heat pump is on,short-press
t emperature value twinkles,press
setting.No any set up after 30 seconds,the controller will save the last setting and go back to original surface.

6.3.3 Set Parameter

When heat pump is on,Long-press
select among Parameter Query/Parameter Setting/Debugging Status/History Fault.Short-press
confirm your selction and switch to
When on status of Parameter Setting ,
password, press
Parameter No.
When on status of Debugging
displays ON or Off. The related mode symbol twinkles after entering into testing mode.

6.3.4 Display on each status:

Parameter Query
Note：Value twinkles,means it is available for changing,or in verse

6.4 Function Diagnosis

When Heat Pump is off, Dial 4 switches to 1, give the heat pump power into status of function diagnosis automatically.
Then display will show each symbol and change every 1 second.
or
into memu,
,press
and to select,press
Displays related parameter value.
, displays the Number, 01 water pump debugging, 02 testing mode, and
Parameter Setting
into water temperature setting surface. Water in area
or to select value,press
%
displays
or select,
and display two"88",it is asking you to enter your
to confirm.When password is right,
Debugging Status
14
to confirm and exit current
Parameter Query,press
displays the value.
Error Query
or
to
displays
V.2