Assembly Instructions For 24 V Dc Electrics - Franke AQRE 432 Instrucciones De Montaje

☞
Important!
• Carefully tighten the solenoid valve cartridge.
• Keep the flush-plugs in the flush-mounting cabinet to enable removal of the
solenoid valve cartridge at a later date.
11.7 Close the flow volume regulator (c) with a screwdriver, 8 mm head width.
☞
Screw the flow volume regulator up to the stop limit.
☞
Important!
Do not remove the circlip.
11.8 Remove the mounting frame from the cover plate by loosening the set screw.
5526 12 24-F (24 V DC)
11.9 Remove the protective earth conductor cable (f).
5526 11 24-F (230 V AC)
11.10 Fasten the protective earth conductor cable (I) to the mounting frame (m).
g Nut
h Tooth washer
j Cable lug
k Pin
11.11 Screw the mounting frame (m) on horizontally. The pin must face inwards.

12. Assembly Instructions for 24 V DC Electrics

12.1 Loosen screw (a) and remove the cover (b) of the connector terminal.
12.2 Connect the 2 x 1.5 mm² cable (c).
12.3 Plug the two connector terminals together.
12.4 Attach the connector terminals to the snap-fit fastener (simplified representation).
12.5 Connect the control unit and the connection terminal with the coupling.
12.6 Connect the control unit with the solenoid valve cartridge.
12.7 Adjust the flush-volume (see
12.8 Adjust the flush flow-rate (see
12.9 Place the cover plate (d) on the frame and hang it behind the flap on the mounting
frame.
12.10 Attach the cover plate with a set screw.
Chapter 15.).
Chapter 16.).
7