Safety Instructions - Oase NEPTUN 600 Instrucciones De Uso

4. Safety instructions

Power connection
The combination of water and electricity can result in serious hazard to life and
limb in the case of improper connection and improper handling.
– For your own safety, please consult an electrician for questions and prob-
– Attention! The device may not be operated with defective casing or defec-
– Attention! Do not operate the device if people are in the water. Unplug the
– Attention! Before you reach into the water, always unplug the power cords
– Compare the mains voltage (V) and mains frequency (Hz) of your power
– Only operate the device from a power outlet installed per directive with earth
– Never use installations, adapters, extension cords or connecting lines without
– Insure that the device is supplied via a residual current protective fixture with
– Electrical installations for garden ponds must correspond to the international
– Do not carry or pull the device by the power cord.
– Keep the plug transformer and all connecting points dry!
– Lay the connecting line in such a way that it is protected to exclude the
– If you require an extension cord: Only use cords that are approved for out-
Operating Instructions
– Attention! Always unplug the power plug before opening the pump filter (2)
– Never pump any liquid other than water!
– Never operate the pump without water (dry-run). The pump bearings will be
– Ensure that the pump is in a stable position before switching it on.
10
Neptun Export.p65
GB Operating instructions
lems!
tive cable!
power cord!
of all devices located in the water.
supply with the data on the nameplate on the plug transformer. This data must
agree.
contact.
earth contact.
a measured residual current of max. 30 mA.
and national construction directives.
possibility of damage.
door implementation. Protect the plug connection from moisture.
for maintenance and cleaning.
destroyed!
10
GB
06.01.2004, 13:21