Agri-Fab 45-01764 Manual Del Usuario página 4

For Agri Fab Discount Parts Call 606-678-9623 or 606-561-4983
10. Place one side panel in position against a side angle
and down on top of the front panel. Start one M6 x 5
screw through the center hole in side panel and side
angle. Secure with hex nut and flat washer. See figure
7. Make only finger tight at this time.
11. Start one M6 x 5 screw through front hole on side panel
and side angle. Start another M6 x 5 screw through
top hole on side panel and front angle assembly. Next,
place a support strap over these two screws and secure
it with flat washers and hex nuts, making only finger
tight at this time. See figure 7.
1. Repeat steps 10 and 11 for the other side panel.
Ф6
FLAT
WASHER
M6
HEX
NUT
M6X25
SCREW
Ф6
FLAT
WASHER
M6
HEX
NUT
SUPPORT
STRAP
FIGURE 7
M6X25
SCREW
M6X25
SCREW
SIDE
PANEL
FRONT
PANEL
FRONT
ANGLE
ASS'Y
www.mymowerparts.com
ENGLISH
13. Assemble one M6 x 5 screw through bottom hole in
side panel and front angle assembly. Secure with a flat
washer and hex nut, making only finger tight at this
time. Repeat for the other side panel. See figure 8.
14. Tighten all loose nuts and screws securely at this
time.
SIDE
PANEL
Ф6
M6
FLAT
HEX
WASHER
NUT
FIGURE 8
4
M6X25
SCREW
FRONT
PANEL
FRONT
ANGLE
ASS'Y