Technical Data; Safety Instructions - DURAVIT C.1 Serie Instrucciones De Montaje Y Uso

These instructions are part of the Duravit
product and must be read carefully and kept
available at all times.
Target readership and qualifications
The product may only be installed by a qualified
plumber.
Explanation of the key words
Addresses practices not
NOTICE
related to physical injury.

Technical data

Operating pressure
Recommended
Max. burst pressure
1 MPa = 10 bar = 145 PSI
Hot water temperature
This unit meets or exceeds the
following:
• ASME A112.18.1
• CSA B125.1
• ADA Compliant
4
MAL_57167/19.03.3

Safety instructions

Cut and crush injuries
> Wear gloves when installing the product.
Product and/or property damage
> Observe the local installation regulations and
> Equalise pressure differences between cold
> Observe the manufacturer's instructions for
> Flush the pipes according to the applicable
max. 125 PSI
50 PSI
500 PSI
max. 140 °F
any country-specific standards at all times.
and hot water connections.
installation with continuous flow heaters.
Malfunction due to dirty
NOTICE
pipes
standards before mounting the pressure
balance trim.