Bevel Cutting; Functional Description; Switch Action - Makita M5802 Manual De Instrucciones

Symbols
The followings show the symbols used for tool.
volts
amperes
hertz
alternating current
no load speed
Class II Construction
revolutions or reciprocation per minute
FUNCTIONAL
DESCRIPTION
CAUTION:
Always be sure that the tool is
switched off and unplugged before adjusting or
checking function on the tool.
Adjusting depth of cut
CAUTION:
After adjusting the depth of cut,
always tighten the lever securely.
Fig.7
► 1. Lever
Loosen the lever on the depth guide and move the base
up or down. At the desired depth of cut, secure the base
by tightening the lever.
For cleaner, safer cuts, set cut depth so that no more
than one blade tooth projects below workpiece. Using
proper cut depth helps to reduce potential for danger-
ous KICKBACKS which can cause personal injury.

Bevel cutting

1
2
Fig.8
► 1. Clamping screw 2. Bevel scale plate
Loosen the clamping screws. Set for the desired angle
(0° - 45°) by tilting accordingly, then tighten the clamp-
ing screws securely.
Sighting
Fig.9
► 1. Cutting line (0° position) 2. Cutting line (45°
position)
For straight cuts, align the 0° position on the front of the
base with your cutting line. For 45° bevel cuts, align the
1
45° position with it.

Switch action

WARNING:
always check to see that the switch trigger actu-
ates properly and returns to the "OFF" position
when released.
6 ENGLISH
1
2
Before plugging in the tool,