Symbols On The Machine; For Safe Operation - IKRA IPCS 2525 Instrucciones De Servicio

3. Symbols on the machine

For safe operation and maintenance, symbols are carved
in relief on the machine. According to these indications,
please be careful not to make any mistake.
a) The port to refuel the „MIX GASOLINE"
Position: near the fuel cap
b) The port to refuel the chain oil
Position: near the oil cap
c) Setting the switch to the "O" position,
the engine stops immediately.
Position: Front at the top of the rear
handle (near the switch)
d) Starting the engine, if you pull out the
choke knob (at the back-right of the rear
handle) to the point of the arrow, you
can set the starting mode as follows.
• First-stage position – starting mode
when the engine is warm.
• Second-stage position – starting mode
when the engine is cool.
Position: Upper-right of the chain cover
e) Adjust the oil pump. If you turn the rod
by screwdriver follow the arrow to the
„MAX" position, the chain oil flow more,
and if you turn to the „MIN" position,
less.
Position: Bottom of the power unit
f) The screw under the "H" stamp is The High-
speed adjustment screw. The screw under
the "L" stamp is The Slow-speed adjustment
screw. The screw at the left of the "T" stamp
is the Idle adjustment screw.
Position: Left side of the rear handle
g) It shows the directions that the chain
brake is released (for the white arrow)
and activated (for the black arrow).
This chain-saw is for trained tree ser-
vice operators only.
Read, understand and follow all warnings.
Appropriate ear, eye, and head protection
must be worn.
Warning! Kickback may occur!
One handed operation of the saw can
be dangerous.
GB | Operating Instructions

4. For safe operation

Before operate the product
4
Read operator's instruction book before oper-
ating this machine.
Do not use the device in humid weather and
store it in a dry location.
Guaranteed sound power level for this equip-
ment. L
WA
1. Before using our products, please read
this manual carefully to understand the
proper use of your unit.
2. Never operate a chain saw when you
are fatigued, ill, or upset, or under the
influence of medication that may make
you drowsy, or if you are under the influ-
ence of alcohol or drugs.
3. Operate the chain saw only in well
ventilated areas. Never start or run the
engine inside a closed room or build-
ing. Exhaust fumes contain dangerous
carbon monoxide.
4. Never cut in high wind, bad weather,
when visibility is poor or in very high
or low temperatures. Always check the
tree for dead branches which could fall
during the felling operation.
5. Use safety slip-resistant footwear, snug
fitting clothing and eye, hearing and
head protection devices.
6. Always use caution when handling fuel.
Wipe up all spills and then move the
chain saw at least ten (10) feet [three
(3) m] from the fueling point before start-
ing the engine.
7. Eliminate all sources of sparks or flame
(ie. smoking, open flames, or work that
can cause sparks) in the areas where
fuel is mixed, poured, or stored. Do
not smoke while handling fuel or while
operating the chain saw.
8. Do not allow other persons to be near
the chain saw when starting the engine
or cutting a wood. Keep bystanders and
animals out of the work area. Children,
pets, and bystanders should be a mini-
mum of 30 feet (10m) away when you
start or operate the chain saw.
9. Never start cutting until you have a clear
work area, secure footing, and planned
retreat path from the falling tree.