tau DC17 Guía Para La Instalación página 27

BATTERY CHARGER KEY
Key:
LED steady on;
LED flashing;
GREEN LED – battery charger status
off
flashing every 2 seconds
continuous flashing
flashing every 4 seconds
steadily lit
RED LED – fault diagnostics
off
steadily lit
continuous flashing
flashing every 2 seconds
AUTOMATIC OPERATION RESETTING - REALIGNMENT
When the board is powered or if the status of the inputs is unknown, the software must realign
the automation to determine the initial position.
The direction of the realignment depends on the program selected and the command given.
ATTENTION: if there are any "motor" alarms, the automatic reset timer is inhibited.
DIAGNOSTICS LEDs AND BUZZER
DL1 DIAGNOSTIC
DL2 - Red POWER SUPPLY 12 V
DL3 - Red POWER SUPPLY 5 V
DL4 - Red AUX POWER SUPPLY 24 V DC
DL5 - Red INSIDE SENSOR
DL6 - Red OUTSIDE RADAR
DL7 - Green PHOTOCELL 1
DL8 - Green PHOTOCELL 2
DL9 - Green EMERGENCY
DL10 - Red CLOSE/LATCHING RELAY Pushbutton
DL11 - Green INTERLOCK
DL12 - Green
SIDE SENSOR
DL13 - Green STOP/ANTI-PANIC
DL1 LED ERRORS
Key:
LED steady on;
LED flashing;
Automation warnings:
green - flashing every 4 seconds
green - continuous flashing
battery charger off;
initial slow charge;
under fast charge;
in backup;
battery charged;
everything OK;
FAULTY battery (cell voltage < than the minimum or .....)
short circuit
battery not connected
automation closed – everything OK;
automation moving (opening/closing);
27