Install The Cutting Line - GreenWorks Pro ST60L03 Manual Del Operador

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

b
a
c
e
4. Clean dirt and debris from all parts. Replace spool (d) if it
is worn or damaged.
5. Align the spool tabs (a) with the tab openings in the base
of the spool (e).
6. Push the spool cover until it clicks into position.
10.4

INSTALL THE CUTTING LINE

Do not put more than 15 feet of cutting line in at a time.
1. Remove the remaining cutting line on the spool.
d
NOTE
English
2. Line up the slots on the spool cover with the slots (a) on
the trimmer head.
3. Insert the line into the mounting hole, which is located
inside the eyelet (b). Push the cutting line until it exits the
opposite hole.
4. Pull the cutting line through until there is an equal
quantity of cutting line on each side.
5. Rotate the spool cover clock-wise in the arrow direction
to wind the cutting line into the trimmer head. Keep
approximately 5 in of cutting line above out of each side
of the trimmer head.
11
EN
a
b

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

St60l413Stc456

Tabla de contenido