INSTALLATION
y Setting up the unit: The unit must be installed on a flat and horizontal floor.
y Electrical connection: flexible conductors with a section of 1 or 2.5 mm2, 2 phases + ground, PVC insulation in a polyu-
rethane sheath.
y The unit must be connected to a single-phase earthed 16 Amp female plug (13A for UK), and will be connected under the
control of a high-sensitivity differential circuit breaker with protection against current overloads.
OPERATION
y This appliance is used to maintain the heating temperature and cannot be used for re-heating or cooking.
y In line with applicable regulations, dishes placed on the product must be at a temperature in excess of 63°C.
y End of use: turn off the device with the 0/1 button. Do not unplug the loaded device directly with the power cord.
TECHNICAL FEATURES
Exterior l x w x h
Net weight
Maximum load
Voltage
Power
Amperage
IP (Protection index)
Cord length
Castor wheel diameter (2 with brake)
CONTROL FRONT
TURNING ON
y Press the On / Off button.
PRECAUTIONS FOR USE
y This device is not intended to be used by people (including children) with reduced physical, sensory or mental abilities, or
by people with no experience or knowledge, unless they are supervised or have been given prior instructions on how to use
the unit, by a person responsible for their safety. Children should be supervised to ensure that they do not play with the unit.
MAINTENANCE
y Before any maintenance, disconnect the electricity from the unit.
y Let the appliance cool before performing any work.
y Glass parts: window cleaning product. Do not use abrasive or scouring sponges
y General information on stainless steel: The words «stainless steel» can be misleading. This is a steel that «resists» cor-
rosion under certain conditions.
Any type of stainless steel can become corroded:
- austenitic. Example «stainless steel 304» also called 18/10.
- ferritic. Examples: «F17»or «F18TNb».
The resistance to corrosion of stainless steels is linked to the existence of a passive layer of chromium oxide that is
reconstituted spontaneously in contact with the air. Any phenomenon that is contrary to the creation of this layer can cause
corrosion.
It is for this reason that the surface of stainless steel must be periodically cleared of various grime that can be at the origin
of a degradation in terms of the resistance of the passive layer and also ensure that the maintenance steps are properly
complied with. (Preparation for cleaning / cleaning / rinsing / disinfection / rinsing / drying).
Regular maintenance with prolonged rinsing with water is the best way to reconstitute and maintain the passive layer.
ENGLISH
1209x770x1228 mm
79 kg
30 kg
230V single phase 50/60 Hz
870 W
3,8 A
21
2 m
Ø 125mm
5