OHAUS Scout STX Manual De Instrucciones página 6

EN-4
The following Interface Commands will be acknowledged by the Balance. They are
case sensitive.
Command Function
IP Immediate Print of displayed weight (stable or unstable).
P Print displayed weight (stable or unstable).
CP Continuous Print.
SP Print on Stability.
SLP Auto Print stable non-zero displayed weight.
SLZP Auto Print stable non-zero weight and stable zero reading.
xP Interval Print x = Print Interval (1-3600 sec) 0P ends interval Print
0P Turn off Auto Print
H x "text" Enter Header line , where x = line number 1 to 5, "text" = header
H
text up to 24 alphanumeric characters
F x "text" Enter Footer line , where x = line number 1 to 2, "text" = footer
F
text up to 24 alphanumeric characters
Z Same as pressing Zero Key
T Same as pressing Tare Key.
Establish a preset Tare value in displayed unit. x = preset tare value.
xT
Sending 0T clears tare (if allowed).
PT Prints Tare weight stored in memory.
PM Print current application mode (weighing mode).
Set current application mode to x. x depends on application
xM 1M: WEIGH, 2M: COUNT,3M: PERCENT, 4M: CHECK, 5M: DYNAMIC, 6M:
TOTAL, 7M:DENSITY, 8M: HOLD, 9M:MOLE
M Scroll to the next enabled mode.
Print Current weighing unit: g, kg, lb, oz, etc....
PU
Set balance to unit x: g, kg etc.
xU 1U: g, 2U: kg,3U: ct, 4U: N, 5U: oz, 6U: ozt, 7U: dwt, 8U: lb, 9U:lb:oz, 10U:
grn, 11U: thk, 12U: tsg, 13U:ttw , 14U: tola, 15U:c
U Scroll to the next enabled unit.
ON Brings out of Standby
OFF Goes to Standby.
C Begin Span Calibration
AC Abort Calibration.
PSN Print Serial Number.
PV Print Version: print name, software revision and LFT ON (if LFT is set ON).
x# Set Counting APW (x) in grams. (must have APW stored)
P# Print Counting application APW.
Set Percent application reference weight (x) in grams. (must have reference
x%
weight stored)
P% Print Percent application reference weight.
xCO Set Checkweighing Over Limit in grams x.
xCU Set Checkweighing Under Limit in grams x.
PCO Print Checkweighing Over Limit.
PCU Print Checkweighing Under Limit.
xMM Set Molar Mass in g/mol .
PMM Print Molar Mass
xS 0 = print unstable data, 1 = print stable only
0 = New Scout print format (default) ; 1 = Scout Pro print format 1;
xFMT
2 = Scout Pro print format 2;
xRL 0 = disable response; 1 = enable response.
Bluetooth® Interface
3 = for certain POS system.