Interface Installation - OHAUS Scout STX Manual De Instrucciones

Bluetooth® Interface
INTRODUCTION
This Interface Kit is for use with Ohaus Scout STX, SPX, SKX and SJX series
products.

INTERFACE INSTALLATION

Install the Interface module on the mini DIN port (round connector) located at the
rear side of the balance as shown. During this process, please make sure the
balance is powered off.
Notes:

Please make sure the small triangle mark (▲) on the round connector is at
the bottom and then plug in.

The appearance of your model may be different.
SETUP
Upon installation of the interface, the balance will recognize the Bluetooth
Interface and add relevant items to the menu. The display will show " " icon in the
upper right corner. The Device ID and Bluetooth address will be shown in the menu.
Bluetooth Interface Kit can be forward compatible with the Mobile or Tablet Devices
TM*
for Android version 4.3 and Bluetooth 4.0. Please double check your Devices'
system version before connection.
OPERATION
Bluetooth APP installation: install the apk file on your
Mobile or Tablet for Android
The apk file can be obtained either by scanning the QR
code or by going to the below link and from there
download it. Then unzip the file to install it.
http://dmx.ohaus.com/WorkArea/showcontent.aspx?id=4294974211
* Android is a trademark of Google Inc.
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG,
Inc. and any use of such marks by OHAUS is under license.
TM
.
EN-1
Mini DIN port
(Round connector)
®*