Tools Required; Fitting The Measuring Rod - Seca 777 Instrucciones De Uso Y Garantía

Fitting the measuring rod

14 •

Tools required

In addition to the scope of delivery, you require the following tools:
Slot-head screwdriver
Cross-head screwdriver
Proceed as follows to fit the measuring rod to the column.
1. Lie the column down on the floor.
2. Place the spacer sleeves on the bores in the column.
3. Extend the upper telescopic element far enough to expose the lower
4. Position the measuring rod on the spacer sleeves as shown in the
5. Place a slot-head screw in the lower assembly bore and the spacer sleeve
6. Tighten the slot-head screw.
7. Extend the upper telescopic element far enough to expose the upper
assembly bore in the lower telescopic element.
diagram.
underneath it.
assembly bore in the lower telescopic element.
Tool Size
1x5.5 mm
PH 2