Disinfecting The Device; Transporting And Setting Up The Device; Transporting The Device; Setting Up The Device - Seca 777 Instrucciones De Uso Y Garantía

4.3 Disinfecting the device

4.4 Transporting and setting up the device

Transporting the device

Setting up the device

8. Fit the cover panel:
a) Insert cover panel
b) Place and tighten two cross-head screws
► Disinfect the following components before initial commissioning
(➔ "Disinfecting", page 26):
– Column and recessed handle
– Display head and display unit
– Measuring rod, head slide with measuring flap
– Weighing platform
– Handrail (optional accessory)
The device is equipped with two casters to facilitate transport over short
distances.
1. If necessary, remove the plug-in power supply unit from the power socket
and from the device.
2. Fold down the measuring flap and push the upper telescopic element of
the measuring rod into its lowest position.
3. Take hold of the recessed handle of the device.
CAUTION!
Injury from device falling over
► Ensure that you have a firm hold of the device when transporting it.
4. Tilt the device until it can be moved freely on the casters.
5. Move the device slowly and carefully over door sills.
6. Transport the device to its new setup location.
CAUTION!
Incorrect measurement as a result of incorrect setup location and
incorrect ambient conditions
Soft floors such as wooden hallways, for example, give under the
patient's weight and falsify the measuring result. Incorrect ambient
conditions lead to measurement errors.
► Select a setup location with a level, stable floor in order to achieve
precise measuring results.
► Use the device only in the intended ambient conditions
(➔ "Technical data", page 29).
English
Starting up device • 19