Bolts And Tools; Assembling The Scales - Seca 685 Manual De Instrucciones Y Garantía

Bolts and tools

The following small parts and tools are included in the supplied equipment:
• 16 galvanized M6 x 12 countersunk bolts
• 8 black covers for M6 countersunk bolts
• 6 galvanized J 6.4 crown gears
• 4 galvanized M8 x 20 oval headscrews
• 4 galvanized 8.4 washers
• 8 white covers for M6 countersunk bolts
• 4 galvanized B 3.5 x 9.5 pan-head tapping screws
• 4 galvanized 6.4 washers
• 4 galvanized M6 x 20 oval head screws
• 1 SW4 hexagon wrench
• 1 SW5 hexagon wrench
• 1 size 1 Philips-head screwdriver
• 1 SW 8/10 socket wrench
• 1 SW 10 combination wrench

Assembling the scales

1. Unscrew the three nuts from the bolt
on the sides of the weighing plat-
form.
2. Place the right element on the rear
bolt of the weighing platform.
3. Swing the side element back behind
the level support.
4. Place the side element onto the
middle and front bolt of the weighing
platform.
5. Place the crown gear and nut onto
the middle bolt and tighten it firmly by
hand.
26