Safety Regulations; Proper Use; Technical Data; Layout And Items Supplied - ALPHA-TOOLS A-BSG 310 Manual De Instrucciones

Important!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.

1. Safety regulations

The corresponding safety information can be
found in the enclosed booklet.
Caution!
Read all safety regulations and instructions.
Any errors made in following the safety regula-
tions and instructions may result in an electric
shock, fi re and/or serious injury.
Keep all safety regulations and instructions
in a safe place for future use.

2. Layout and items supplied

2.1 Layout (Fig. 1)
1. Handle
2. Drill bit guide hole
3. Opening for emptying grinding dust
4. On/Off switch
5. Power cable
2.2 Items supplied
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, please keep the packaging until
the end of the guarantee period.
Important!
The equipment and packaging material are
not toys. Do not let children play with plastic
bags, foils or small parts. There is a danger of
swallowing or suff ocating!
Anl_A-BSG_310_SPK7.indd 12 Anl_A-BSG_310_SPK7.indd 12
GBR
•
Drill bit grinder
•
Original operating instructions
•
Safety instructions

3. Proper use

The drill bit grinder is designed for grinding drill
bits for working with metal (HSS bits) with diame-
ters of 3-10 mm.
The equipment is to be used only for its prescri-
bed purpose. Any other use is deemed to be a
case of misuse. The user / operator and not the
manufacturer will be liable for any damage or inju-
ries of any kind caused as a result of this.
Please note that our equipment has not been de-
signed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.

4. Technical data

Mains voltage: ......................... 230-240 V ~ 50 Hz
Power consumption: .............. 55 W S3 50% 2 min
Idling speed: ........................................1500 min
Drill bit diameter: ................................... 3-10 mm
Protection class:............................................II /
Weight: .......................................................2,1 kg
S3 50%: Intermittent mode, no start-up, no bra-
king (cycle duration 2 minutes). In intermittent
mode, the percentage load factor (50%) is always
quoted so that the heat generated during this pe-
riod can be dissipated during breaks in operation
by convective cooling. Intermittent mode consists
of the on time and the cooling breaks, known as
the duty cycle. The period of consideration is 2
minutes. 50% load factor means that the electric
tool can be operated for one minute at the rated
performance, followed by a cooling phase of one
minute.
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
- 12 -
-1
23.02.12 14:50 23.02.12 14:50