Before Starting The Equipment - ALPHA-TOOLS A-BSG 310 Manual De Instrucciones

L sound pressure level ........................ 76 dB(A)
pA
K uncertainty ............................................. 3 dB
pA
L sound power level .......................... 89 dB(A)
WA
K uncertainty ............................................. 3 dB
WA
Wear ear-muff s.
The impact of noise can cause damage to hea-
ring.
Keep the noise emissions and vibrations to a
minimum.
•
Only use appliances which are in perfect wor-
king order.
•
Service and clean the appliance regularly.
•
Adapt your working style to suit the appliance.
•
Do not overload the appliance.
•
Have the appliance serviced whenever ne-
cessary.
•
Switch the appliance off when it is not in use.
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain resi-
dual risks cannot be rules out. The following
hazards may arise in connection with the
equipment's construction and layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear protec-
tion is used.

5. Before starting the equipment

Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Always pull the power plug before making
adjustments to the equipment.
Anl_A-BSG_310_SPK7.indd 13 Anl_A-BSG_310_SPK7.indd 13
GBR
6. Operation
6.1 ON/OFF switch (Fig. 1/Item 4)
Switching on:
Set the ON/OFF switch (4) to "I".
To switch off :
Set the ON/OFF switch (4) to "0".
6.2 Drill bit guide holes (Fig. 2 / Item 2)
The sixteen drill bit guide holes (2) are each
marked with a value which corresponds to the
diameter in mm of a drill bit (see Fig. 2). Check
whether the drill bit you wish to grind is marked
with one of the diameters listed below.
3,0 mm; 6.5 mm;
3,5 mm; 7,0 mm;
4,0 mm; 7.5 mm;
4,2 mm; 8,0 mm;
4,5 mm; 8,5 mm;
5,0 mm; 9,0 mm;
5,5 mm; 9,5 mm;
6,0 mm; 10 mm
6.3 Grinding drill bits (Fig. 2+3)
•
Switch on the machine. See 6.1
•
Insert the drill bit in the required drill bit guide
hole (2) with the blunt tip of the drill bit first.
See also 6.2
•
Hold the drill bit as shown in Fig. 3 and press
the drill bit for approx. 5-10 seconds by apply-
ing light pressure to it
•
The time required to grind the drill bit may be
longer or shorter depending on the thickness
of the bit
•
Then take the drill bit out and turn it through
180° in order to grind the other end of the drill
bit tip
•
Insert the drill bit in the equipment again for
another 5-10 seconds
•
Repeat the process until the grinding results
meet your expectations.
•
Now you can remove the ground drill bit and
use it for drilling again
Important.
Switch off the equipment when you no longer use
it!
- 13 -
23.02.12 14:51 23.02.12 14:51