Electrical Connection - Sinmag Europe HS-3 Manual Del Usuario

3.2 Installation
This appliance shall be installed with sufficient ventilation to prevent the occurrence of
unacceptable concentrations of health harmful substances in the room.
Installations must be carried out by qualified service persons only. Failure to install
equipment to relevant codes and manufacturer's specifications in this section will void
the warranty.
Components having adjustments protected (e.g. paint sealed) by the manufacturer are
only to be adjusted by an authorised service agent. They are not to be adjusted by the
installation person.
It is the responsibility of the owner to supply and arrange for the connection of all
services to the machine.
3.3 Unpacking
On receipt of the machine, carry out the following: Remove all packaging and transit
protection including all protective plastic coverings from outer panels.
Check equipment and parts for damage. Report any damage immediately to the carrier
and dealer. Never attempt to operate the machine with damaged parts.
Report any deficiencies to the dealer that supplied the machine.
3.4 Location
1.
Select a location for the machine with a minimum of 0.6m space around the
machine for operating, cleaning and servicing.
2.
Position the machine in its proper working position. The machine must be installed
on a flat, solid and dry floor.
3.
It is recommended that the machine is level from front to back and from side to side.
This will ensure the greatest stability.

3.5 Electrical connection

1.
An electrical supply should be available within the reach of the included power cord.
Do not use extensions to connect the machine's power cord to the electrical supply.
2.
Before making the electrical connections, read the specifications on the rating plate
to ensure that they comply with those of the electrical supply. Electrical connection
should be made by a qualified service technician who will observe all applicable
safety codes and the national electrical codes.
3. Check the correct connection (rotation) of the machine. If connected wrong, the
motor will run, but the knives will not move. If necessary, you will have to exchange
the position of 2 phase wires.
When connecting this machine to the mains supply, ensure that the following is carried out:
1.
An isolating switch is fitted within 2m of the machine.
2.
A grommet/gland is fitted around the power supply cord entry hole into the machine.
3.
All wiring connections must be checked and tight.
Once the electrical connection has been made, the machine is ready for use.
ELECTRICAL SUPPLY REQUIREMENTS 220VAC, 50Hz, 1PH+E
SINMAG EUROPE BVBA
ENG
5