Overload Protection - Makita XBU02 Manual De Instrucciones

CAUTION:
Always install the battery cartridge
fully until the red indicator cannot be seen. If not,
CAUTION:
Do not install the battery cartridge
forcibly.
Indicating the remaining battery
capacity
Only for battery cartridges with the indicator
1. Indicator lamps 2. Check button
light up for a few seconds.
Indicator lamps
Lighted Off
NOTE: Depending on the conditions of use and the
1
2
-
Remaining
capacity
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
malfunctioned.
Tool / battery protection system
placed under one of the following conditions:
Status
Overload
Overheat
Over
discharge

Overload protection

debris, and the middle indicators start blinking and
In this situation, turn the tool off and stop the application
that caused the tool to become overloaded. Then turn
the tool on to restart.
NOTICE:
Depending on the usage conditions,
the tool is automatically turned off without any
indication if the tool is overloaded by entangled
branches or debris. In this case, switch off the
tool and remove the battery cartridge, and then
remove entangled branches or debris using tools
such as pliers. After removing the branches or
debris, install the battery cartridge and turn on
the tool again.
Overheat protection for tool or
battery
heating occurs,
tool on again.
Overdischarge protection
If the tool does not operate even when the switches are
6 ENGLISH
Indicator lamps
On Off
indicator blinks.
indicator blinks.
-
-
Blinking