Makita XBU02 Manual De Instrucciones página 34

9. Insert the protrusion on the shear blades to the
hole on the rod, then align the position of the felt pad
with the holes on the tool, and then attach new sleeves
and washers.
3
2
4
5
1. Protrusion 2. Hole 3. Felt pad 4. Washer
5. Sleeve
NOTICE:
Apply a small amount of grease to the
inner periphery of the hole of the rod.
NOTICE:
Be careful not to lose the washers and
the sleeves.
10. Align the holes on the shear blades with the holes
blades.
1
1. Screw 2. Hole
1
2
10 ENGLISH
11. Attach the rod.
2
1. Rod 2. Small hole
NOTICE:
Apply a small amount of grease to the
inner periphery of the small hole of the rod.
NOTICE:
Make sure that the protrusion on the
12. Attach the plate.
1. Protrusion 2. Plate
NOTICE:
Make sure that the protrusion on the
13. Attach the cover, and then tighten 6 screws.
1. Cover 2. Screw
1
2
1
1
2