Westinghouse LD-0003-07/WH/GS/55 Manual De Instrucciones página 7

INSTALL THE LIGHT BASE TO FAN
1) Loose the screw (1-Fig.5) from base bracket.
Align two slot screws with the keyhole slots
of light base.
2) Turn the light base counterclockwise until slot
screws are firmly at the end of slots.
3) Then secure back screw 1 to the base bracket.
Tighten all three screws. Do not over-tighten.
4) Connect the upper plug from motor to the
lower plug in the light base.
INSTALL THE LIGHT DOME TO LIGHT BASE
Lift and align the light dome to light base, let
the bolt go through the big keyholes of slot and
turn the light dome clockwise. Finally let the bolt
seat in the small keyholes of slot.
CHANGE THE BULB
Unplug the lamp socket from circular lamp. Pull the
circular lamp out from spring clips. Finally replace it
with new circular lamp.
Base Bracket
Slot Screw
Slot
Bolt
Spring Clip
7
Screw 1
Light Base
Figure 5
Light Dome
Figure 6
T5 Circular
Lamp
Figure 7
GS-78013-WH09