Parts Supplied; Operating Conditions - Dornbracht 36.751.850. Instrucciones De Montaje

36.751.850.FF
140 140 170
35
100-30
Fig. 1
36.752.850.FF
140 140 200
35
100-30
Fig. 2
Fig. 3

1.0 PARTS SUPPLIED

e-MOTE infrared wall-mounted washbasin
mixer ON-OFF function,
exposed trim parts:
36.751.850.FF
Projection 170 mm
36.752.850.FF
Projection 200 mm
Infrared wall-mounted washbasin mixer
concealed rough parts: wall housing in wall
35.730.970.90
installation box
Exposed trim parts:
• Covering rosette complete with
- Infrared sensor
- Flow reducer, 5 l/min
- Aerator, M 16 x 1
- 6 Volt lithium battery
• Mounting frame
• Set of fixtures
concealed rough parts:
• Wall housing in wall installation box with
- Solenoid valve
- Mixer
- 2 supply stops
- 2 back flow preventers with dirt trap
- 2 connections, G 1/2
- High pressure connector hose
• Set of fixtures
• Set of drain fittings

2.0 OPERATING CONDITIONS

Recommended feed temperature
Maximum feed temperature (temporary)
Minimum flow pressure
Maximum flow pressure 10 bar
Recommended operating pressure 1-5 bar
Test pressure 16 bar
Noise class I / ISO 3822
Flow rate approx. 5 l/min
Battery Lithium 6 V, 2 CR 5
Battery life Approx. 5 years
when used 200 times a day
Reception range: 100 - 30 mm
Safety shutoff After 10 sec
Enclosure rating
Mark of conformity
At an idle pressure of more than 5 bar, the insta-
llation of a pressure reducer to DIN 1988 in the
supply line is recommended.
The fittings are not suitable for use in conjunction
with pressureless storage water heaters.
When operated in conjunction with hydraulic flow
heaters, flow reducer 11 must be removed.
Observe DIN 1988 in the case of newly installed
pipe systems.
3.0 FUNCTION
ON/OFF function
When the hands are placed within approx.
100-30 mm of the infrared sensor, the mixer is
switched on. The mixer cuts out again if the hands
are moved within the infrared sensor's range a
second time. If the hands are not moved towards
the sensor a second time, the mixer automatically
cuts out after 10 sec.
Battery display
If the LED in the upper sensor lens 1 flashes, the
mixer is no longer operational.
The lithium battery 15 must be changed.
See 5.0 CHANGING THE BATTERY.
4.0 INSTALLATION
Concealed rough parts
Installed height 150-200 mm above washbasin
upper edge.
65° C
Align wall housing horizontally with wall installation
80° C
box and secure with the enclosed fastening
1 bar
materials. Installed position see
Connect up pipes:
Cold-water connection (KW) = right (blue)
Hot-water connection (WW) = left (red)
Insert the enclosed drain plug in the place of the
back-flow preventer (RV).
Rinse the pipes.
Then insert the back-flow preventer (RV) again.
Open the supply stop.
IP 45
Fit the bare brickwork protective hood.
The distance between the tiles and the wall
installation box may be no more than 5 mm.
Fig. 8
Fig. 4
Fig. 3
Figs. 1 + 2
OFFEN
Fig. 5 OPEN CLOSED
OPEN
Fig. 4
Fig. 5
Fig. 5
Fig. 6
Fig. 6
3
RV
ZU
GB
CLOSED
4