Electric Connection; Operate Your Bottle Refrigerator - Jocel JAG003355 Manual De Instrucciones

•
Before connecting the appliance to the power source, let it stand upright for approximately
2 hours. This will reduce the possibility of a malfunction in the cooling system from
handling during transportation.
•
Keep space between machine and the wall to make it proper air ventilation
•
Clean the interior surface with lukewarm water using a soft cloth.
•
Place your appliance on a floor that is strong enough to support the appliance when it is
fully loaded. To level your appliance, adjust the front legs at the bottom of the appliance.
•
For recedes installation away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase
electrical consumption. Extreme cold or hot ambient temperatures may also cause the
appliances not to perform properly.
•
Not designed for placement in adage or basement.
•
The appliance is for indoor use only.
Caution: Please keep the appliance away from substance, which can cause ignition.
VI. Electrical Connection
Improper use of the grounded plug can result in the risk of electrical shock. If the power
cord is damaged, have it replaced by the Technical Assistance.
This unit should be properly grounded for your safety. The power cord of this unit is equipped
with a 2-pin plug which mates with 2-pin wall outlets to minimize the possibility of electrical
shock. Do not under any circumstances cut or remove the ground wine from the power cord
supplied.
Use of extension cords is not recommended.
This unit requires a standard electrical outlet.
The cord should be secured behind the bottle refrigerator and not let exposed or dangling to
prevent accidental injury.
VII. Operating Your Bottle refrigerator
It is recommended that you installed the bottle refrigerator in a place where the ambient
temperature is between 10-25℃.If the ambient temperature is above or below recommended
temperatures, the performance of the unit may be affected.
For example, placing in extreme cold or hot conditions may cause interior temperature to
Warning
-25-