Operation instructions
From off position the stand-by control mode can be activated by pressing any button. The symbol
will then light up softly giving the user the possibility to see and choose the function.
By pressing one more time any button will activate the corresponding function and the symbol will
then light up completely. To ensure a low level of energy consumption, this control has a special
device which lets the symbols remain lighted up half way, in a stand mode, for about 1
minute. The symbols will switch off afterwards.
The cooker hood is provided with 6 keys.
A
A: ON/OFF button- atmosphere light: by pressing this button 4 lights situated at the back of the
hood and on the sides will switch on giving a decorative effect with a soft light
B: ON/OFF button- hood's light : by pressing this button 2 lights will switch on lighting the hob
C: ON/OFF button- 4 speed motor: by pressing this button the hood will start to operate at
the same speed as before being switched off. By using D and E it is possible to change the
extracting speed (capacity)
D: Decreasing extracting speed (capacity) button: by pressing this button the extracting speed
(capacity) will decrease
E: Increasing extracting speed (capacity) button: by pressing this button the extracting speed
(capacity) will increase
F: ON/OF TIMER: by pressing this button the selected extracting speed (capacity) will last for
5 minutes, after that the hood will automatically turn itself of.
Grease filters saturation
After every 40 hours of use of the hood, the
speed indicator will flash slowly indicating that
the metal filters need to be washed.
Charcoal filters saturation
After every 120 hours of use of the hood, the
speed indicator will flash fast indicating that
the charcoal filters need to be replaced.
1
B
C
D
Note: by pressing at the same time the but-
tons D and E will reset the filters saturation
indicator.
Attention! This function should only be used af-
ter performing the maintenance of the filters.
E
F