Tripp-Lite NGS8C2POE Manual Del Propietário página 4

Product Features
1 Power ON/OFF LED: Illuminates to indicate the switch is receiving power.
2 Gigabit Ethernet Ports with PoE Support: 8 or 24 twisted-pair RJ45 ports support
auto-negotiable 10/100/1000 Mbps and auto MDI/MDIX cross-over detection functions
for true "plug-and-play" capability. Any RJ45 port can be configured to supply up to
30 watts PoE (Power over Ethernet). PoE is transmitted over existing network cables to
attached devices like VoIP phones, wireless access points, and surveillance cameras.
Model
NGS8C2POE
NGS24C2POE
3 Gigabit Port Status LEDs: For 10/100 Mbps connections, these LEDs illuminate
orange and blink to indicate activity on each port. When the switch discovers a
1000 Mbps connection, the LEDs will illuminate green for connection status and blink
to indicate activity on each port.
4 PoE Status LEDs: The PoE Status LEDs illuminate amber when an active PoE
connection is detected. The LED will blink when a port is overloaded or may have a
short circuit.
5 SFP Port LED: The green LED is ON when a connection is present and blinks when the
port is active.
6 SFP Ports: The SFP (small form-factor pluggable) ports are connection points for Mini-
GBIC modules and Direct SFP cables so the switch can uplink to other switches using
optical fiber or copper. When the SFP ports are active, the associated LEDs will react to
interface traffic.
7 Console Port: This RJ45 port is used for command line access to the switch.
8
Reset Button: Pressing the reset button for 5 seconds performs a factory reset. The
system restores the factory defaults when the reset occurs.
9 AC Input: This 100-240V 50/60 Hz C14 inlet accepts the supplied AC power cord or
any country-specific AC power cord supplied by the user.
10 Equipment Grounding Lug: Use this screw to connect devices that require a chassis
ground connection.
17-04-027-93368F.indb 4
PoE Power Per Port
Up to 30W
Up to 30W
4
Maximum PoE Power
140W
300W
4/5/2017 3:47:17 PM