Configuration
Accessing the Management Configuration Interface
After powering the switch for the first time, the Network Gigabit Smart Switch can be
configured using a Web browser. To access the switch, the management computer and the
switch must be set to the same subnet. The IP address of the management computer must
be configured manually. The switch's default IP address is 192.168.2.1 and the default
subnet mask is 255.255.255.0. The default username and password are case-sensitive.
The default username is admin and the default password is admin.
The Network Gigabit Smart Switch contains software for viewing, monitoring and
management. This management software is not required for the switch to function. The
ports can be used without the management software. However, the management software
enables setup of VLAN, Trunking and other additional features. The use of these features
can improve the efficiency of the switch, which will result in improved overall performance
for both the hardware and the network.
For more information about configuring the switch, visit www.tripplite.com and access the
NGS-Series Network Gigabit Smart Switch Web Configuration Guide.
7
17-04-027-93368F.indb 7
4/5/2017 3:47:20 PM