Tripp-Lite SRCOOL12K Manual Del Propietário página 5

Installation
2-3
Connect the flexible cooling duct (shorter tube
the duct with the circular adapter opening, push the duct downward and turn the duct
clockwise until it screws into the adapter solidly.
2-4
Place the other end of the cooling duct near the air intake of the target device or rack
enclosure, using the straightest, shortest path available. If you plan to cool a rack
enclosure, place the end of the cooling duct over a perforated area near the top of the
enclosure's front door (or near the top of the bank of equipment that requires cooling).
Cool air will sink and spread across the air intakes at the front of the rack enclosure.
Exhaust Duct Connection
3
3-1
Connect the flexible exhaust duct (longer tube
panel of the unit
and turn the duct clockwise until it screws into the exhaust vent solidly.
3-2
Connect the other end of exhaust duct
with the circular adapter opening, push the duct inward and turn the duct clockwise until it
screws into the adapter solidly.
If you plan to connect the exhaust duct to a drop ceiling, proceed to step
connect the exhaust duct to a window, proceed to step
Book 1.indb 5
(continued)
A
) to the cooling duct adapter
A
) to the warm air exhaust vent on the rear
B
. Align the duct with the circular vent opening, push the duct inward
A
to the exhaust duct adapter
B
. Align
B
. Align the duct
4
. If you plan to
5
.
5
A
2-3
2-4
A
B
3-1
A
3-2
B
B
7/29/2011 9:34:39 AM