Safety System; Loading Staples - Makita BST221 Manual De Instrucciones

Do not use force when inserting the battery
•
cartridge. If the cartridge does not slide in easily, it
is not being inserted correctly.

Safety system

1
009151
Make sure all safety systems are in working order before
operation. The tool must not operate if only the switch
trigger is pulled or if only the safety lever is pressed
against the wood. It must work only when both actions
are performed. Test for possible faulty operation with a
tool unloaded and pointed well away from yourself or
any bystanders.
NOTE:
There is a possibility that the tool may operate for
•
an instant when only the trigger is pulled. This does
not indicate a problem. If this occurs, point the tool
well away from yourself or any bystanders.
Release and pull the trigger again to make sure the
safety systems are in working order.
ASSEMBLY
CAUTION:
Always make sure that your fingers are not placed
•
on the trigger and the battery cartridge is removed
before carrying out any work on the stapler.
Staples
Handle the staples and their box carefully. If the
•
staples have been handled roughly, they may be
bent out of shape, causing poor staple feed or
jamming.
Avoid storing the staples in a very humid or hot
•
place or place exposed to direct sunlight.
CAUTION:
Do not use staples other than designated in this
•
manual or staples that appear to be damaged, bent,
rusty or corroded.
Do not insert staples of which size is different each
•
other at the same time inside the magazine ,
causing poor staple feed or jamming.
1. Trigger
2. Safety lever
2

Loading staples

Remove the battery cartridge.
Press the locking lever on the rear of the sub magazine
and slide the sub magazine backward.
009152
Load staples into the main magazine with their feet
facing up. Slide the sub-magazine forward.
009153
To secure the sub magazine in place, hook the locking
lever on the rear of the sub-magazine.
CAUTION:
With the magazine loaded, if the tool is held
•
downward and the sub-magazine is opened, the
staples can fall out and present a danger to anyone
or anything below. Keep this in mind especially
when working in high locations.
Unloading staples
CAUTION:
When removing staples, make sure that your
•
fingers are not placed on the trigger or the lever
and the battery cartridge is removed from the
stapler. Misfiring may cause personal injuries and
property damage.
Remove the battery cartridge.
Press the locking lever and slide the magazine back.
5
1. Sub magazine
1
2. Locking lever
2
1. Staples
1
2. Main magazine
2