Wall Mounting - Fakir 2000 TS Instrucciones De Uso

2000TS-8606.QXD 22.06.2006 11:52
A
If you want to mount the fan heater on the wall
• Select a spot near a socket, but not directly underneath it, and ensure the minimum
distances (page 3) from the wall and from the ceiling and/or floor.
• To fit the wall holder, hold it against the wall at the intended spot like drawing [A], and
mark the positions of the fastening holes with a sharp pencil.
• Ensure that the holder is horizontal and that the holes are clear of electric cables and
pipes.
• Drill the holes at the marked points and insert plastic pougs. Then screw the wall hol-
der in tight.
• Slide the fan heater (while holding it vertical) into the wall holder by its rear face and
mark the lower fastening position according sketch [C].
• Drill the hole at the marked point, insert the plug and fix the bathroom heater with the
screws according sketch [B+C].
Caution: When fitting the base as the wall holder, ensure that no curtains, towels or
other inflammable objects can be hung in front of the fan heater later on. This
could cause overheating.
D
Mounting of the towel-dryer:
D 1 Insert the metal tube into the plastic holder
D 2 centre and
D 3 fix it with the screw.
D 4 Insert the towel-dryer into the aperture at the lower part
of the appliance until it snaps.
Attention: Due to safety reasons the heating power of the appliance is limited to
1000 watts when the towel-dryer is inserted.
10
Seite 10

Wall mounting

B
D D
C
D