Springlane Hanno Manual De Instrucciones página 24

1. Prepare your ingredients following
the recipe. Particularly heavy or hard
ingredients should first be chopped
up before adding them to the mixing
container.
2. Place the appliance on a level and dry
surface and insert the plug into the
socket.
3. Place the container on the motor base.
Ensure that it is correctly secured. To
activate the security mode, the handle
needs to be positioned to the front
right when putting on the container;
otherwise, the device cannot start.
4. Remove the lid and add your
ingredients to the container. We
recommend adding solid ingredients
first and liquid ingredients afterwards.
5. Make sure that you do not exceed the
max. filling level.
6. Place the lid on the container and
press it down to secure it onto the
container. The security contact will not
be activated otherwise.
7. Connect the power plug to the
connector.
8. To start the high-performance blender,
set the speed using the controller dial.
Select the switch control to start the
high-performance blender. Attention:
The high-performance blender only
works if the controller dial is initially
set to "OFF". Dial the controller dial
24
back to "OFF" if the mixer does not
start operation.
9. Set the controller dial to automatic
function (MODE) to select between
the functions "Pulse", "Crushed Ice",
"Smoothie", and "Grinding". The
button you pressed lights up and the
selected programme starts. Pressing
the button again stops the programme
and all four buttons will light up again.
You can now select a new function.
10. You can measure and add further
ingredients during operation through
the small opening in the lid, using the
removeable measuring cup with 65 ml
filling volume.
11. Let the motor wind down completely
before removing the mixing container.
Never remove it from the base while
the blender is still in operation or while
the motor is still running.
12. If you are finished using the blender,
unplug the device and clean the
container and individual parts.
Speed controller
The speed controller stops the blender or
restores the rotation speed.
Important: The device can only be
operated if the controller is initially set to
position "OFF".